Sony MLS-X1 Users Guide - Page 246

Setting the Image Effect Function This section describes the M/E-1 menu as an example. Assigning a DME channel to a background bus Note Only one DME channel can be used on each background bus. 1 Open the Home > M/E-1 > Bus/Transition > Bus > Image Effect menu (11109.12). 2 In the [Image Effect] group, select the target background bus to set. Background A: Background A bus Background B: Background B bus 3 In the [DME Select] group, select a DME channel (DME 1 to DME 4) to assign. You can check the DME channel status using the button display. On: DME channel assigned to the selected background bus Off: DME channel not assigned Lock icon: DME channel assigned to a different key/ bus To select a DME channel assigned to a different key or bus Use the override function. You can release the DME channel assignment for another key/bus and then select the DME channel. To enable the override function, set the [Override] button to the on state. The DME channel is assigned to the selected background bus and the lock icon displayed on the DME channel button disappears. Note The button used to execute the image effect function must be assigned to the cross-point pad/function button section of the cross-point control block beforehand. For details about assigning buttons in the cross-point pad, see "Setting a Cross-Point Pad" (page 410). For details about assigning buttons in the function button section, see "Assigning Control Panel Buttons" (page 402). 1 Press the [IMAGE] button, turning it on. Use the [IMAGE] button for the cross-point button row assigned with the background A bus. 2 Select a signal on the background A bus. The signal set by the DME effect is output. Executing the Image Effect Function The image effect function can be executed on the crosspoint control block of the target switcher bank. The DME effect to use for the image effect function must be configured for the DME channel beforehand. This section describes the background A bus as an example. 246