Sony MLS-X1 Users Guide - Page 126
Selecting Signals Key Control, Block, Selecting the key fill/key source signals
View all Sony MLS-X1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 126 highlights
To swap color 1 and color 2 in a color mix Set the [Color Invert] button to the on state. To set modifiers for a color mix pattern You can press the [Pattern Adjust] button and set the following modifiers from the displayed menu. When the [Key Wipe] button is selected in the [Mix Pattern] group, the Home > M/E-1 > Key1 > Transition > Wipe menu (11101.52) is recalled. When the [Key Edge Pattern] button is selected in the [Mix Pattern] group, the Home > M/E-1 > Key1 > Edge > Matte Adjust menu (11101.22) is recalled. Position: Set the [Position] button to the on state and set the parameters. For details about setting parameters, see "Setting the wipe pattern position (Position)" (page 158). Multiplication: Set the [Multi] button to the on state and set the parameters. For details about setting parameters, see "Replicating a wipe pattern (Multi)" (page 159). Aspect: Set the [Aspect] button to the on state and set the parameters. For details about setting parameters, see "Setting the aspect ratio of a wipe pattern (Aspect)" (page 159). Rotation (angle): Set the [Angle] button in the [Rotation] group to the on state and set the parameters. For details about setting parameters, see "Rotating a wipe pattern (Rotation)" (page 158). Rotation (speed): Set the [Speed] button in the [Rotation] group to the on state and set the parameters. For details about setting parameters, see "Rotating a wipe pattern (Rotation)" (page 158). Selecting the key fill/key source signals You can select a key fill signal and a key source signal in the menu. For details about selecting a signal in the cross-point control block, see "Selecting a Key Fill Signal/Key Source Signal" (page 91) and "Selecting a Video Signal/ Key Signal" (page 91). To select a key fill signal 1 Open the Home > M/E-1 > Key1 > Type > Signal Select menu (11101.14). 2 Press the [Edit] button for [Fill]. The [Key Fill Bus] window appears. 3 Set the button for the target video signal to the on state. Select a tab to change the cross-point button number to display. 4 Press [OK]. To select a key source signal When the key source signal is set to split mode, select a key source signal. 1 Open the Home > M/E-1 > Key1 > Type > Signal Select menu (11101.14). 2 Press the [Source Type] button for [Source], and select video signal/key signal from the pull-down list. Video: Video signal Key: Key signal 3 Press the [Edit] button for [Source]. The [Key Source Bus] window appears. 4 Set the button for the target video signal/key signal to the on state. Select a tab to change the cross-point button number to display. 5 Press [OK]. Selecting Signals (Key Control Block) Setting a key fill/key source Select the target key to set and press the page selection button to display page 2/3 of the setting buttons. Set the signals to insert in the key fill and key source using the key fill/key source selection buttons. 1 Set the key fill signal using the [MAT FILL] button. To set a color matte Press the [MAT FILL] button, turning it on green. The parameters will vary depending on the menu color matte settings (single color or mix). For details about setting a color matte, see "Setting a key fill color mix" (page 125). When single color is selected, set the following parameters. 126