Sony MLS-X1 Users Guide - Page 363

Setting the Box Configuration Setting a Switcher Bank/Multi Viewer In a multiple-box switcher configuration, you can configure a hardware block for use as a switcher bank or as a multi viewer. The supported hardware blocks are given below. • When the system signal format is 2160P M/E box: Block 1, 2 Cross-point box: Block 1 • When the system signal format is 1080P or 1080i M/E box: Block 1, 2, 3, 4 Cross-point box: Block 1, 2 1 Open the Home > Setup > System > Format/Config > Box Config menu (19101.24). 2 Select a tab (Logical Box ID 1 to Logical Box ID 5) to switch the target to set. 3 In the [Box Config] group, select whether the hardware block is used as a switcher bank or as a multi viewer for each block. M/E: Enable a switcher bank. Enhanced MV: Enable an enhanced multi viewer. Standard MV: Enable a standard multi viewer. Notes • An enhanced multi viewer cannot be set to the following. - When the system signal format is 2160P: M/E box block 2 - When the system signal format is 1080P or 1080i: M/E box block 3, 4 • A standard multi viewer cannot be set to the following. - When the system signal format is 2160P: M/E box block 1 and cross-point box - When the system signal format is 1080P or 1080i: M/E box block 1, 2 and cross-point box 4 Press the [Apply] button. To return to the previous setting Press the [Clear] button. 5 Check the message, then press [OK]. The switcher system reboots. Setting M/E split You can split an M/E hardware block (physical M/E block) of the switcher for use as two sub blocks. You can assign a logical M/E to each sub block. For details about assigning a logical M/E, see "Assigning a logical M/E" (page 387). Notes • Enabling M/E split will disable multi program 2 mode. • When M/E split is enabled, the Out5 to Out8 outputs cannot be used. • When M/E split is enabled, the keys that can be used in a single physical switcher block can be assigned to the two sub blocks. You can set the number of keys to assign. For details about setting keys, see "Setting sub block full keys" (page 387). 1 Open the Home > Setup > System > Format/Config > Box Config menu (19101.24). 2 Select a tab (Logical Box ID 1 to Logical Box ID 5) to switch the target to set. 3 Select the [M/E Split] switch for the target physical M/E block to the on state. To disable M/E split, set the [M/E Split] switch to the off state. 4 Press the [Apply] button. To return to the previous setting Press the [Clear] button. 5 Check the message, then press [OK]. The switcher system reboots. Setting a GPU The DME and SL key functions use a GPU. When the system signal format is 2160P, either the DME function or SL key function can be enabled. Note To use the DME function, the MZS-X1610 3D DME License (option) is required. To use the SL key function, the MZS-X1620 SL Key License (option) is required. 1 Open the Home > Setup > System > Format/Config > GPU Config menu (19101.25). 363