Sony MLS-X1 Users Guide - Page 405
Assigning a Utility Function, Setting Transition Rate Display, Mode Buttons, Setting an Action
View all Sony MLS-X1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 405 highlights
shared main and sub, the assignable button assignments are also shared. 4 Set the button for the function to assign to the on state. To release a function assignment Set the [No Assign] button to the on state. 5 Press [OK]. To return assignable button assignments to the defaults Press the [Default Recall] button, check the message, then press [OK]. Setting Transition Rate Display Mode Buttons You can select the transition rates to display in the memory recall section when the [TRANS RATE1] button to [TRANS RATE3] button in the utility/shotbox control block is pressed to switch to transition rate display mode. You can assign the transition rate for common transitions and independent key transitions for each switcher bank. 1 Open the Home > Setup > Panel > Module > Trans Rate Mode Assign menu (19104.24). 2 Select the target transition rate display mode to set. Select a tab to change the transition rate display mode (Trans Rate 1 to Trans Rate 3) to display. The three transition rate display modes correspond to the [TRANS RATE1] button to [TRANS RATE3] button. 3 Press the target memory recall button to set. The [Select Function] window appears. The assignable transition rates are displayed in the [Select Function] window. Select a tab to change the switcher bank to display. 4 Set the button for the transition rate to assign to the on state. 5 Press [OK]. Assigning a Utility Function You can assign the following functions (actions) to the memory recall buttons in the utility/shotbox control block, the memory recall buttons in the utility control block, and the cross-point buttons in the cross-point control block. • Utility command • Recalling a macro register • Recalling a shotbox register • Menu shortcut Setting an Action Assigning a utility command You can assign a utility command function to a button. You can set the name to display on the memory recall buttons in the utility/shotbox control block and utility control block, or on the display in the cross-point control block. 1 Open the Home > Setup > Panel > Module > Utility Function Assign menu (19104.22). 2 Display the target control block to set. Select a tab to change the control block to display. [Utility Module] tab: Utility/shotbox control block or utility control block [XPT Module] tab: Cross-point control block 3 Select the target button to set. The target button to set is displayed in "bank numberbutton number" format. To select and set multiple buttons, place a check mark beside the target buttons to set. To select and set all buttons, place a check mark in the Select All checkbox. 4 Press the [Action Group] button and select [Util Command] from the pull-down list. 5 Press the [Edit] button for [Action]. The [Select Action] window appears. 6 Set the button for the command to assign to the on state. Select a tab to change the action to display. 405