Sony MLS-X1 Users Guide - Page 111
Setting the Independent Key, Transition Rate, Checking the independent key transition
View all Sony MLS-X1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 111 highlights
2 Select a transition type in the [Transition Type] group. Mix: Mix Wipe: Wipe DME Wipe: DME wipe Cut: Cut When an operation mode that supports configuration of transitions where keys are inserted/removed independently is set, select a transition type for key insertion in the [ON Transition Type] group and a transition type for key removal in the [OFF Transition Type] group. 3 Set the transition type. Make the required settings for the selected transition type. When a mix, wipe, or DME wipe is selected Set the transition rate. For details about the transition rate, see "Setting the Independent Key Transition Rate" (page 111). When a wipe is selected Set the wipe pattern. For details, see "Setting an Independent Key Transition Wipe" (page 158). When a DME wipe is selected Set the DME wipe pattern. For details, see "Setting an Independent Key Transition DME Wipe" (page 170). Checking the independent key transition type setting On the ICP-X7000, you can check the transition type on the display in the independent key transition execution section of the transition control block, display in the independent key transition control block, or display in the key fader control block. The transition type is indicated by the letters "M" (mix), "W" (wipe), "D" (DME wipe), and "C" (cut). Note When the transition rate is set to timecode display, the transition type is not displayed. Setting the Independent Key Transition Rate You can set the time taken from the beginning of an independent key transition to its completion. The independent key transition rate is configured using the utility/shotbox control block and numeric keypad control block, or the menu. Note When an operation mode that supports configuration of transitions where keys are inserted/removed independently is set, the transition rate for inserting and removing keys can be set separately. For details about independent key transition operation mode, see "Setting the Independent Key Transition Mode" (page 394). Setting the independent key transition rate (utility/shotbox control block and numeric keypad control block) When the utility/shotbox control block is switched to transition rate display mode, the transition rate is displayed in the memory recall section. Press a memory recall button to select a transition rate, and set it using the numeric keypad control block. Note You can change the transition rate display mode transition rate assignments. For details, see "Setting Transition Rate Display Mode Buttons" (page 405). 1 Press the [TRANS RATE1] button to [TRANS RATE3] button in the utility/shotbox control block. The memory recall section switches to transition rate display mode. 2 Press the memory recall button displaying the transition rate of the target key to set, turning it on. The target region name and transition rate to set are shown on the display of the numeric keypad control block. In operation modes that support configuration of transitions separately for when keys are inserted/ removed, configuration while a key is not inserted sets the transition rate for key insertion and configuration while a key is inserted sets the transition rate for key removal. 3 Enter a transition rate using the numeric keypad of the numeric keypad control block. You can switch the input mode using the [TC] button. In frame number input mode, enter three digits. In timecode input mode, enter four digits. 111