Sony MLS-X1 Users Guide - Page 283
Saving a Snapshot, Snapshot for a region other than a, switcher bank, Switcher bank region snapshot
View all Sony MLS-X1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 283 highlights
The memory recall section switches to display the selected bank. 4 Press the button for the target register to recall. The register button is lit orange and the snapshot is recalled. Snapshot for a region other than a switcher bank 1 Display the [Snapshot] taskbar. Snapshot recall/store mode is activated. 2 Press the [Recall/Store] button. The [Recall/Store Register] window appears. 3 Set the button for the target region to the on state. You can select multiple regions. For details about the display in the region display section, see "Region display section" (page 283). Select a tab to change the region to display. [ME] tab: Switcher bank regions [User] tab: User regions [DME] tab: DME regions [External Device] tab: External device regions The first selected region becomes the reference region. To select all regions configured beforehand Set the [All Regions] button to the on state. For details about setting the regions selected simultaneously, see "Setting Regions Selected Simultaneously" (page 402). Note The region selection is common for snapshots and effect timelines. 4 Press the [Recall] button. 5 Enter a register number in the numeric keypad area. For details about selecting a register, see "Selecting a register" (page 283). To add the auto transition temporary attribute Set [Auto Trns] in the numeric keypad area to the on state. To add the effect dissolve temporary attribute Set [Effect Diss] in the numeric keypad area to the on state. Note In the [Recall/Store Register] window, it is not possible to add the cross-point hold temporary attribute. You can use the bus override function and the crosspoint button row cross-point hold function. For details, see "Cross-Point Hold" (page 90). 6 Press [Enter]. The specified register is recalled. To undo a register recall To undo a recall immediately after recalling a register, press the [Undo] button. To set the duration for an effect dissolve temporary attribute You can set the duration for an effect dissolve temporary attribute for each region. Select the target region to set, press the [Temp Diss Duration] button, and enter a duration (number of frames) for the effect dissolve in the numeric keypad area. Selecting a register Select a register using the numeric keypad area at the bottom right of the [Recall/Store Register] window. Enter a register number in the numeric keypad area and press [Enter] to apply the setting. When you enter a register number, the register number and the following information appears on the numeric keypad area display. e: The register is empty for the currently selected region. E: The register is empty for all selectable regions. L: The register is locked. To search for an empty register, press [.] (period). To search for an empty register common to all selectable regions, press [.] (period) again. Note Searching for an empty register is enabled only when saving a snapshot. Region display section The region display section at the top right of the [Recall/ Store Register] window shows the region selection status. The selected regions are displayed in white characters. The reference region is displayed highlighted. Saving a Snapshot Switcher bank region snapshot The same memory recall buttons as in the memory recall section of the Flexi Pad control block are displayed in the Common > Snapshot menu of the switcher bank. The 283