Sony MLS-X1 Users Guide - Page 377
Setting 100G IP Input/Output Signals, Setting an ST 2110 Stream, Setting Multicasting
View all Sony MLS-X1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 377 highlights
[HDR Converter] window > [Config] tab Configure in the same way as for an input signal. For details, see "[HDR Converter] window > [Config] tab" (page 371). Note Only the [Master Black (Abs.)] button and [HDR Black Offset] button settings are available in the [Black Level] group for an output signal. [HDR Converter] window > [Conversion] tab Configure in the same way as for an input signal. For details, see "[HDR Converter] window > [Conversion] tab" (page 371). Note This cannot be set when the system OETF and output signal OETF are set to [SDR]. [HDR Converter] window > [Additional Paint] tab Configure in the same way as for an input signal. For details, see "[HDR Converter] window > [Additional Paint] tab" (page 372). Returning [HDR Converter] window settings to the initial settings Press the [Default Recall] button in the [HDR Converter] window. The settings on all tabs in the [HDR Converter] window are returned to the following values. [Config] tab: System settings values [Conversion] tab: System settings values [Additional Paint] tab: Default values Setting 100G IP Input/ Output Signals Setting an ST 2110 Stream You can set whether to send redundant ST 2110 streams (input/output). 1 Open the Home > Setup > System > 100G IP Input/ Output > Config menu (19101.52). 2 Enable/disable using the [Hitless Failover] button. On: Send redundant ST 2110 streams (input/output). Off: Do not send redundant ST 2110 streams (input/ output). 3 Press the [Apply] button. To return to the previous setting Press the [Clear] button. 4 Check the message, then press [OK]. Setting Multicasting You can configure multicasting for each output of boxes configured in a switcher. For details about output numbers, see "Input/Output Numbers" (page 503). Notes Cannot be configured in the following cases. • When [NDCP(LSM)] is configured in the [Protocol] group in the Home > Setup > 100G IP I/F > Controller > Protocol menu (19108.21) • When [NMOS] is configured in the Setup > 100G IP I/F > Controller > Protocol menu (19108.21) and [Stop] is configured in the [Device Connection Mgmt (IS-05) Start Up Mode] group in the Home > Setup > 100G IP I/F > Controller > NMOS menu (19108.22) 1 Open the Home > Setup > System > 100G IP Input/ Output > Output Multicast menu (19101.54). 2 Select a tab to switch the target to set. [Video] tab: Change video settings [Audio] tab: Change audio settings [Meta] tab: Change metastream settings 377