Sony MLS-X1 Users Guide - Page 391
Setting a Multi Viewer, Setting Multi Viewer Display, Contents
View all Sony MLS-X1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 391 highlights
Setting a Multi Viewer A multi viewer is a function that splits the screen for display of multiple images at the same time. You can set a hardware block (physical block) of the switcher for a multi viewer and assign it to a channel. When the system signal format is 2160P, you can use two multi viewers (multi viewer 1, multi viewer 2). When the system signal format is 1080P or 1080i, you can use four multi viewers (multi viewer 1, multi viewer 2, multi viewer 3, multi viewer 4). Note The multi viewer output image has a 2-frame delay. Setting Multi Viewer Display Contents 1 Open the Home > Setup > Switcher > Multi Viewer > Config menu (19103.21). 2 Display the target multi viewer to set. Select a tab to change the multi viewer to display. [MV1] tab: Multi viewer 1 [MV2] tab: Multi viewer 2 [MV3] tab: Multi viewer 3 [MV4] tab: Multi viewer 4 3 Press the [Split Mode] button and select a split pattern from the pull-down list. You can select from eight patterns. Split into 4: Split 4 Split into 10: Split 10-1, Split 10-2 Split into 13: Split 13-1, Split 13-2, Split 13-3, Split 13-4 Split into 16: Split 16 4 Set whether to display/hide a border using the [Enable Border] button. On: Display border lines on subscreen. Off: Do not display border lines on subscreen. Tally display Tallies are shown on the multi viewer screen for the signals used in the on-air image. The tally is represented by subscreen borders using the following three colors. Red: Image with red tally (on-air tally) Green: Image with green tally Yellow: Image with yellow tally Note When [Independent] is selected in the [Tally Type] group in the Home > Setup > Panel > Custom > Button Tally menu (19104.64), tallies are not displayed on the multi viewer screen. To set the display positions of the signal name and audio level meter You can set the display positions of the signal name and audio level meter to inside or outside a subscreen. Note For Standard MV, the signal name is displayed at the top left inside the subscreen and the audio level meter is grayed out. In the [Information Position] group, select the display position. Inside Window: Displays the signal name at the bottom and audio level meters on the left and right inside the subscreen. Outside Window: Shrinks the subscreen and displays the signal name at the bottom and audio level meters on the left and right outside the subscreen. Assigning signals Note The following output signal settings are not reflected on the multi viewer screen. Safe title, AUX bus color corrector, AUX mix 1 Open the Home > Setup > Switcher > Multi Viewer > Config menu (19103.21). 2 Display the target multi viewer to set. Select a tab to change the multi viewer to display. [MV1] tab: Multi viewer 1 [MV2] tab: Multi viewer 2 [MV3] tab: Multi viewer 3 [MV4] tab: Multi viewer 4 3 Press the button for the target subscreen to set. The [Select Displayed Signal] window appears. 4 Set the button for the target signal to the on state. Select a tab to change the type of signal to display. [PP/ME Out] tab: Switcher bank output signals [FM/Clip/DME] tab: Frame memory, clip player, and DME monitor output signals [Aux] tab: AUX, edit preview, preset output signals [Input 1-50] tabs: Input signals 1 to 50 [Input 51-100] tabs: Input signals 51 to 100 391