Sony MLS-X1 Users Guide - Page 390
Setting Extended Re-Entry, Setting a DME Channel, Setting a User Region
View all Sony MLS-X1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 390 highlights
• Home > Setup > Switcher > Config > PGM Config menu (19103.13) • Home > Setup > Switcher > Config > K-PVW Config menu (19103.14) The settings are common to all switcher banks. 1 Open the Home > Setup > Switcher > Config > M/E Config menu (19103.12). 2 Set the [Recall M/E Config] button to the on state. Setting Extended Re-Entry When extended re-entry is enabled, selection of re-entry signals on the same switcher bank becomes possible. In multi program 2 mode, selection of re-entry signals between main and sub also becomes possible. Notes • The extended re-entry settings are common to all switcher banks. • Stacked re-entry may cause problems in the image. • The selection order of re-entry signals affects the number of lines by which the output signal is lowered. 1 Open the Home > Setup > Switcher > Config > M/E Config menu (19103.12). 2 Set the [Extended M/E Re-Entry] button to the on state. 3 Check the message, then press [OK]. Setting a DME Channel Setting a DME channel to use in a switcher bank You can set a DME channel to use on switcher bank for a processed key or DME wipe. 1 Open the Home > Setup > Switcher > Config > DME Config menu (19103.16). 2 Select the target switcher bank to set. 3 Press the [Edit] button for [DME Channel]. The [Select DME Channel] window appears. 4 Place a check mark in the DME channels to enable. 5 Press [OK]. Setting a User Region You can assign the following regions to User 1 to User 8. • Color Bkgd 1, Color Bkgd 2 • Aux 1 to Aux 48 • Frame Memory 1 to Frame Memory 16 • Clip Player 1 to Clip Player 4 Note If you change the user region settings, the previously saved snapshot data and effect timeline data can no longer be used. 1 Open the Home > Setup > Switcher > Config > User Region Config menu (19103.17). 2 Select the target region to set. To select and set multiple regions, place a check mark beside the target regions to set. To select and set all regions, place a check mark in the Select All checkbox. 3 Press the [User Region] button and select a user region (User 1 to User 8) from the pull-down list. When you do not want to assign a user region Select [No Assign] from the pull-down list. To return to the previous setting Press the [Clear] button. 4 Press the [Apply] button. 5 Check the message, then press [OK]. 390