Sony MLS-X1 Users Guide - Page 436
Setting Tally Generation
View all Sony MLS-X1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 436 highlights
Setting Tally Generation You can set the reference destination and tally type for tally generation. The tally generation settings are common to both parallel tally and serial tally. 1 Open the Home > Setup > Router/Tally > Tally > Tally Enable menu (19106.23). 2 Select the target tally to set. To select and set multiple tallies, place a check mark beside the target tallies to set. To select and set all tallies, place a check mark in the Select All checkbox. You can also press the [Select Number(s)] button and enter a tally number in the numeric keypad window. 3 Press the [Destination] button and enter an address for a destination in the numeric keypad window. 4 Press the [Level] button and enter a level (1 to 8) in the numeric keypad window. 5 Press the [Edit] button for [Tally Type]. The [Select Tally Type] window appears. 6 Set the button for the target tally to the on state. R1 to R8: Tally type 1 to 8 for red tally G1 to G8: Tally type 1 to 8 for green tally Y1 to Y8: Tally type 1 to 8 for yellow tally 7 Press [OK]. 8 Press the [Tally Enable] button and select a tally generation mode from the pull-down list. Tally Input: Generate tally from the tally input state. Enable: Always generate tally. Disable: Never generate tally. To set a tally input port When [Tally Input] is selected, you can set a tally input port. The number for a parallel input port is displayed in "logical box ID (1 to 3) -board (1 to 3) -number (1 to 6)" format (for example, "1-3-6"). 1 Select the target tally to set and press the [Edit] button for [Tally Input]. The [Select Tally Input] window appears. 2 Select a tab (Box 1 to 5). 3 Set the button for the target parallel input port to the on state. Note Ports on boards 2 and 3 can be used when an MKS-X1700 Legacy Interface Board (option) is installed. 4 Press [OK]. To delete a tally generation setting Select the target tally to delete and press the [Delete] button. 436