Sony MLS-X1 Users Guide - Page 396
Setting Keys/Wipes, Setting the Operation Mode When
View all Sony MLS-X1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 396 highlights
Setting Keys/Wipes Setting the Key Memory Mode 1 Open the Home > Setup > Switcher > Custom > Key/ Wipe menu (19103.43). 2 Select the target switcher bank to set. 3 Press the [Key Memory] button and select a key memory mode from the pull-down list. Full: Set to full mode. Simple: Set to simple mode. Off: Disable key memory. Setting the Mask/Border Processing Mode 1 Open the Home > Setup > Switcher > Custom > Key/ Wipe menu (19103.43). 2 Select the target switcher bank to set. 3 Press the [Mask/Border Process] button and select a mask/border processing mode from the pull-down list. M > B (Mask > Border): Apply the mask effect, then apply the border effect. B > M (Border > Mask): Apply the border effect, then apply the mask effect. Setting the Key Priority Mode 1 Open the Home > Setup > Switcher > Custom > Key/ Wipe menu (19103.43). 2 Select the target switcher bank to set. 3 Press the [Key Priority] button and select a key priority mode from the pull-down list. Normal: Set the key priority arbitrarily. Fix: Fixed at the currently set key priority. Setting the Cross-Point Hold Operation Mode You can set the cross-point hold operation mode on a key bus. The cross-point hold operation mode is also applied to snapshot attributes. 1 Open the Home > Setup > Switcher > Custom > Key/ Wipe menu (19103.43). 2 Select the target switcher bank to set. 3 Press the [Xpt Hold Mode] button and select a cross- point hold operation mode from the pull-down list. Key Disable: The cross-point hold button of the key bus functions as a key disable set button. When the cross-point hold button is enabled, the cross-point selection information and the key settings information are not applied, even when a snapshot or effect timeline is recalled. Key Dsbl with Status: Same as [Key Disable], but also does not reflect the key on/off status. Xpt Hold: The cross-point hold button of the key bus functions as a cross-point hold set button. When the cross-point hold button is enabled, the cross-point selection information is not applied, even when a snapshot or effect timeline is recalled. Setting the Operation Mode When the Pattern Limit is Released 1 Open the Home > Setup > Switcher > Custom > Key/ Wipe menu (19103.43). 2 Select the target switcher bank to set. 3 Press the [Pattern Limit Transition] button and select an operation mode for when a pattern limit is released from the pull-down list. Auto: When the pattern limit is released, the remainder of the transition is executed automatically at a dedicated transition rate. Manual: After the pattern limit is released, the transition waits for the next operation, then executes. The transition is not executed until you operate the fader lever or press the [AUTO TRANS] button. 396