Sony MLS-X1 Users Guide - Page 385
Setting the Cross-Point Delay, Copying a Cross-Point Assign Table, Copying a Table
View all Sony MLS-X1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 385 highlights
Setting the Cross-Point Delay Copying a Cross-Point Assign Table You can set a delay so that cross-point switching occurs after a specified delay has elapsed since selecting the cross-point. You can use this in combination with the advanced tally function to output a tally prior to the actual switching of the cross-point. For details about advanced tally, see "Setting Advanced Tally" (page 437). Notes • Cross-point delay is enabled only when cross-points are selected manually. • Cross-point delay is enabled for re-entry signals if the re-entry contains an image with cross-point delay set. When cross-point delay is set for multiple images, the largest delay value is the one applied. 1 Open the Home > Setup > Xpt Assign > Xpt Delay menu (19102.61). The logical V/K pair number, logical V/K pair name, and cross-point delay setting are displayed. 2 Select the target logical V/K pair number to set. To select and set multiple logical V/K pair numbers, place a check mark beside the target logical V/K pair numbers to set. To select and set all logical V/K pair numbers, place a check mark in the Select All checkbox. 3 Set the [Xpt Delay] switch to the on state. To disable a cross-point delay, set the [Xpt Delay] switch to the off state. 4 Press the button on the right of the [Xpt Delay] switch and enter a delay value (0 to 180) in the numeric keypad window. The delay setting varies as follows depending on the system signal format. 2160P, 1080P: Delay by set number of frames 1080i: Delay by set number of fields Copying a Table You can copy settings between cross-point assign tables. 1 Open the Home > Setup > Xpt Assign > Table Copy menu (19102.71). A list of copy source tables is shown on the left, and a list of copy destination tables is shown on the right. 2 Select copy source and copy destination tables. 3 Press the [Copy] button. 4 Check the message, then press [OK]. Copying a Table to a Remote Panel You can use the same cross-point settings as the switcher on a remote panel for the network AUX remote panel function by copying the cross-point assign table. For details about the network AUX remote panel function, see "Setting a Network AUX Remote Panel" (page 453). Notes • After copying, the remote panel settings data is overwritten. • After copying, the function button settings on the remote panel change as follows. - Top left button: Status function - Top right button: Source/Destination/Level function - Bottom left button: Assign function - Bottom right button: Lock Chop function 1 Open the Home > Setup > Xpt Assign > Table Button Assign menu (19102.31). 2 Display the target table to set. Select a tab to change the table (Table1 to Table14) to display. 3 Press the [Select Panel] button in the [Copy to Aux Remote Panel] group. The [Select Panel] window appears. 385