Sony MLS-X1 Users Guide - Page 448
Setting NDCP (LSM
View all Sony MLS-X1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 448 highlights
Setting NDCP (LSM) You can configure the required setting using the ST 2110 routing function of LSM (Live System Manager). Note When the protocol is set to NMOS, NDCP(LSM) cannot be configured. 1 Open the Home > Setup > 100G IP I/F > Controller > NDCP(LSM) menu (19108.14). 2 Select the target LAN port to set. To select and set multiple LAN ports, place a check mark beside the target LAN ports to set. To select and set all LAN ports, place a check mark in the Select All checkbox. 3 Check the DHCP setting state. Enable: Obtain LSM address automatically using DHCP is enabled. Disable: Obtain LSM address automatically using DHCP is disabled. Note Set to "Disable" (fixed). 4 Set the [LSM Enable] switch. On: Use the port for control communication with LSM. Off: Do not use the port for control communication with LSM. Note LAN port 1-1-1 is set to "On" (fixed), and "Enable" is displayed. 5 Press the [LSM IP Address] button and enter an address using the keyboard. Note Cannot be set when [LSM Enable] is turned off. 6 Press the [Apply] button. To return to the previous setting Press the [Clear] button. 7 Check the message, then press [OK]. To check the LSM (Live System Manager) connection status You can check the LSM connection information for each 100G port using [Connection Status] in the Home > Setup > 100G IP I/F > Controller > NDCP(LSM) menu (19108.14). Connected: Connected Disconnected: Disconnected Note At least one 100G port on each box must be connected. 448