Sony MLS-X1 Users Guide - Page 210

Nonlinear Effects It is not possible to apply two or more nonlinear effects at the same time. Enabling an effect automatically disables the previously enabled effect. This section describes the menu for DME channel 1 as an example. Setting a Nonlinear Effect Select a type of nonlinear effect to enable. 1 Open the Home > DME > Channel1 > Non Linear > Effect List menu (15101.51). 2 Press the button for the nonlinear effect to enable. The setup menu for the selected nonlinear effect appears and nonlinear effects become enabled. To disable nonlinear effects Press the [Off] button. Setting a Page Turn In the Home > DME > Channel1 > Non Linear > Effect List menu (15101.51), press the [Page Turn] button to display the Home > DME > Channel1 > Non Linear > Page Turn menu (15101.52). In the Home > DME > Channel1 > Non Linear > Page Turn menu (15101.52), set the [Page Turn] button to the on state and set the following parameters. No. Parameter 1 Radius 2 Offset 3 Angle Adjustment Radius of the turned page flap Amount of page turn Angle of page turn To split an image In the [Split Mode] group, select a type of split. H&V: Split horizontally and vertically (top, bottom, left, right) H: Split horizontally (left, right) V: Split vertically (top, bottom) To select a signal to insert on the back side of the page In the [Back Video] group, select a signal. Self: Same signal as the front side Flat: Single color Hue Rotation: Gradually varying hue 2nd Channel: 2nd channel signal When the [Flat] button is selected, set the following parameters. No. Parameter 1 Luminance 2 Saturation 3 Hue Adjustment Luminance Saturation Hue When the [Hue Rotation] button is selected, set the following parameters. No. Parameter 1 Luminance 2 Saturation 3 Speed Adjustment Luminance Saturation Speed at which the hue changes Note To set a 2nd channel signal, a DME channel for the second channel must be selected beforehand. For details about selecting a DME channel, see "DME Effects for Keys" (page 134). Setting a Roll In the Home > DME > Channel1 > Non Linear > Effect List menu (15101.51), press the [Roll] button to display the Home > DME > Channel1 > Non Linear > Roll menu (15101.53). In the Home > DME > Channel1 > Non Linear > Roll menu (15101.53), set the [Roll] button to the on state and set the following parameters. No. Parameter 1 Radius 2 Offset 3 Angle Adjustment Radius of the rolled portion Amount of roll Angle of roll To split an image In the [Split Mode] group, select a type of split. H&V: Split horizontally and vertically (top, bottom, left, right) H: Split horizontally (left, right) V: Split vertically (top, bottom) To select a signal to insert on the back side of the roll In the [Back Video] group, select a signal. Self: Same signal as the front side Flat: Single color Hue Rotation: Gradually varying hue 2nd Channel: 2nd channel signal When the [Flat] button is selected, set the following parameters. 210