Sony MLS-X1 Users Guide - Page 139
Setting Rotation, Rotating a key menu
View all Sony MLS-X1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 139 highlights
To change the position and size of a key Press the [LOC SIZE] button, turning it on, and adjust the setting values using the trackball/Z-ring. To change the rotation and viewpoint position of a key Press the [ROT] button, turning it on, and adjust the setting values using the trackball/Z-ring. To finely adjust the setting values of parameters Press the [FINE] button, turning it on. The adjustment mode switches to fine mode, enabling fine adjustment of setting values using the trackball/ Z-ring. To restrict the parameters targeted by the operation Press the [X] button, [Y] button, or [Z] button, turning it on. This enables operation only for the selected axis using the trackball/Z-ring. Transforming an image using trackball/Z-ring operations You can transform an image as follows using trackball/ Z-ring operations for each two-dimensional transform. Button ASP PERS LOC SIZE ROT Trackball Z-ring Horizontal direction Vertical direction Change aspect ratio in X-axis direction Change aspect ratio in Y-axis direction Simultaneous change aspect ratio in X-axis direction and Y-axis direction Movement in X-axis direction Movement in Y-axis direction Scaling (shrink/ magnify) Rotation around Y-axis Rotation around X-axis Change distance from viewpoint position Device control block display In the device control block of the ICP-X7000, the display shows the following information. • Reference switcher bank name: M/E1 to M/E5, P/P • Reference resizer name: KEY1 RSZR to KEY8 RSZR • Selected parameter name: ASP, LOC SIZE, ROT PERS, BDR, CROP • X-axis, Y-axis, and Z-axis settings (four edge settings for crop) To adjust the setting values of parameters using the numeric keypad control block You can press the [X] button, [Y] button, or [Z] button in the device control block to display the name and value of parameters on the display of the numeric keypad control block and then set the X-axis, Y-axis, and Z-axis parameters. Enter a value in the numeric keypad area and press the [ENTER] button to apply the setting. Note You can also enter a difference value from the currently set value using the [TRIM] button. For details, see "Entering a difference from a current value" (page 79). To change parameters to the closest detent position Press the [CTR] button once. To return two-dimensional transform parameters to the default values Press the [CTR] button twice. Or press and hold the [SHIFT] button and press the [CTR] button. To return two-dimensional transform parameters to the initial settings Press the [CLR WORK BUFR] button once. The two-dimensional transform parameters return to the initial status saved data setting values. To return all resizer parameters to the initial settings Press the [CLR WORK BUFR] button twice. Or press and hold the [SHIFT] button and press the [CLR WORK BUFR] button. The resizer parameters return to the initial status saved data setting values. To return a switcher bank to the initial settings Press the [M/E DEF RCALL] button twice. The selected switcher bank returns to the initial status saved data setting values. Setting Rotation Rotating a key (menu) 1 Open the Home > M/E-1 > Key1 > Resizer/Proc Key > Resizer Adjust/DME Select menu (11101.41). 2 Set the [Resizer] button to the on state. 3 In the [Rotation] group, select a direction of rotation. X: Rotation in horizontal direction Y: Rotation in vertical direction When the [X] button is selected, set the following parameters. 139