Sony MLS-X1 Users Guide - Page 361
Setting the System Configuration, Initializing the System, Setting Dual Simul Mode
View all Sony MLS-X1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 361 highlights
3 Enable/disable the function using the [Load and Recall Initial Status] switch. On: Enabled. Off: Disabled. Setting the System Configuration Initializing the System Initializing the switcher/control panel You can initialize and reboot the switcher or control panels. The following modes can be selected. Reset: Reboot according to the startup mode setting. All Clear: Clear the memory and reboot using the factory default settings. 1 Open the Home > Setup > System > Start Up menu (19101.11). 2 Select the target to set. Select switcher or control panel. 3 Press the [Initialize] button and select an initialization mode from the pull-down list. Reset: Reset and reboot. All Clear: Clear all memory and reboot. 4 Press the [Apply] button in the [Initialize] group. To return to the previous setting Press the [Clear] button in the [Initialize] group. 5 Check the message, then press [OK]. Note The cross-point box does not reboot after initialization. Initializing the system setup You can restore the settings of the setup menus to the defaults (setup all clear). 1 Open the Home > Setup > System > Start Up menu (19101.11). 2 Press the [Setup All Clear] button. 3 Check the message, then press [OK]. The switcher system reboots. Setting Dual Simul Mode When dual simul mode is enabled, two switchers can be controlled simultaneously from a single control panel. Notes • The first switcher is a switcher in the same switcher system as the control panel. For the second switcher, specify a switcher from another switcher system. • The status of the first switcher is displayed on the control panel and in the menu. 1 Open the Home > Setup > System > Format/Config > Config menu (19101.21). 2 Set the [Dual Simul] button to the on state. To disable dual simul mode, set the [Dual Simul] button to the off state. 3 Press the [2nd Switcher IP Address] button and enter the IP address of the second switcher using the keyboard. 4 Press the [Apply] button. To return to the previous setting Press the [Clear] button. 5 Check the message, then press [OK]. The switcher system reboots. Dual simul mode menus The following menus can be operated for two switchers at the same time. • Home > M/E-1 to M/E-5 • Home > M/E-1 Sub to M/E-5 Sub • Home > P/P • Home > P/P Sub • Home > Frame Memory > FMx/FMx > Clip/Still > Recall (FMx/FMx = FM1/FM2 to FM15/FM16) • Home > Frame Memory > FMx/FMx > Clip/Still > Play (FMx/FMx = FM1/FM2 to FM15/FM16) • Home > Clip Player > Clipx/Clipx > Clip > Recall (Clipx/Clipx = Clip1/Clip2 to Clip3/Clip4) • Home > Clip Player > Clipx/Clipx > Clip > Play (Clipx/ Clipx = Clip1/Clip2 to Clip3/Clip4) • Home > DME • Home > Other Effects • Home > Utility 361