Sony MLS-X1 Users Guide - Page 454
Configuring a System Controller, Configuring NS-Bus
View all Sony MLS-X1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 454 highlights
Note All the connected remote panels are rebooted. To display the latest status Press the [Refresh] button. Deleting a remote panel from the list You can delete a remote panel from the list of remote panels. Note Remote panels connected to a control panel cannot be deleted. 1 Open the System Configuration > Configuration > Aux Remote Panel > Delete menu (20101.23). The remote panel name and IP address of the remote panels are displayed. You can press [Name] to sort the display of remote panels by name. Pressing [Name] switches between ascending and descending order each time it is pressed, and [v] (ascending) or [V] (descending) is displayed on the right side of [Name]. 2 Select the target remote panel to delete. To select and delete multiple remote panels, place a check mark beside the target remote panels to delete. To select and delete all remote panels, place a check mark in the Select All checkbox. 3 Press the [Delete] button. 4 Check the message, then press [OK]. To display the latest status Press the [Refresh] button. Configuring a System Controller Configuring NS-Bus Enabling the NS-Bus External Control protocol You can enable NS-Bus External Control protocol control (A) or (B). 1 Open the System Configuration > Configuration > System Controller menu (20101.31). 2 Set the [Enable Control] button to the on state in the [NS-Bus External Control (A)] group or [NS-Bus External Control (B)] group. To disable NS-Bus External Control protocol control, set the [Enable Control] button to the off state. 3 Press the [IPv4 Address] button in the [NS-Bus External Control (A)] group or [NS-Bus External Control (B)] group and enter an IP address using the keyboard. Setting the UUID of the switcher You can generate a switcher UUID when the NS-Bus External Control protocol control is enabled. 1 Open the System Configuration > Configuration > System Controller menu (20101.31). 2 Press the [Generate] button in the [Switcher UUID] group. 3 Check the message, then press [OK]. A UUID is generated and displayed in the [Switcher UUID] group. When a UUID is generated, the display changes to the new UUID. 454