Sony MLS-X1 Users Guide - Page 233
Executing a Utility Function Utility, Shotbox Control Block
View all Sony MLS-X1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 233 highlights
Command Function AUTO PVW Auto preview Preset PVW Preset preview M/E-x Preview M/E-x preview x = 1 to 5 P/P Preview P/P preview M/E-x Sub Preview M/E-x preview on the sub side in multi program 2 mode x = 1 to 5 P/P Sub Preview P/P preview on the sub side in multi program 2 mode M/E-x K-PVW1 M/E-x K-PVW2 M/E-x key preview 1/key preview 2 x = 1 to 5 P/P K-PVW1 P/P K-PVW2 P/P key preview 1/key preview 2 M/E-x Key1 to 8 Preview b) c) d) M/E-x key 1 to key 8, key preview x = 1 to 5 P/P Key1 to 8 Preview b) c) d) P/P key 1 to key 8, key preview a) Applies only to output signals assigned in the Home > Setup > System > Output > Output Assign menu (19101.41). b) Cannot be assigned to cross-point buttons in the cross-point control block. Status of buttons assigned with a utility command c) Linked to the key preview 1 setting in the Home > Setup > Switcher > Config > K-PVW Config menu (19103.14). d) The target key menu (last recalled menu) is displayed when a button assigned with a utility command is double-pressed. Command GPI 1 to 50 Test Fire Macro Cancel Macro All Cancel Pre Macro Post Macro Macro Take Macro All Take FTB Other commands Utility control block On Flashes light purple only at the moment the button is pressed Lit orange while the button is pressed Lit purple during macro pause (Gray characters displayed on black when the button is disabled) Lit light purple, then lit red when execution ends Lit orange Off Lit purple Lit dark blue Lit light purple during macro execution Lit purple Lit dark blue Cross-point control block On Off Flashes amber only at Not lit the moment the button is pressed Lit amber while the button is pressed Not lit Lit amber during macro Not lit during macro pause execution Lit amber, then lit red Not lit when execution ends Lit amber Not lit Executing a Utility Function (Utility/ Shotbox Control Block) You can perform utility function operations using the memory recall section in the utility/shotbox control block. Press a memory recall button assigned with an action to execute the utility function. Note When using two utility/shotbox control blocks, the action assignments are common to both. Selecting a bank A group comprising the 24 buttons of the memory recall section are called a "bank." There are 20 banks (1 to 20), and you select the target button for operation by switching the bank. Press a [BANK1] to [BANK20] button to switch the memory recall section to function recall mode for the selected bank. Note By default, bank 1 to 6 selection buttons are assigned. To use bank 7 to 20, the bank 7 to 20 selection buttons must be assigned to assignable buttons beforehand. 233