Sony MLS-X1 Users Guide - Page 120

green, the 6th and subsequent parameters (page 2 parameters) are displayed. You can adjust parameters whose setting buttons are lit green. If a button is lit amber, press the button, turning it on green, then perform the operation. To clear the adjustment knob parameter assignment, press the page selection button to switch to another page. The parameter assigned to the adjustment knob is released, and the light of the selected setting button changes from green to amber. Setting a key Select the target key to set. 1 Press the delegation button, turning it on, for the target switcher bank (M/E-1 to M/E-5, P/P) to set. 2 Press the delegation button for the target key (KEY1 to KEY8) to set, turning it on. Auto delegation To enable auto delegation, press the [AUTO DELEG] button, turning it on. On the ICP-X7000, you can switch the key selection of the key control block automatically in sync with the following control block buttons. • Transition control block: [KEY1] to [KEY8] buttons • Cross-point pad in the cross-point control block: key 1 to 8 bus delegation buttons [KEY1] to [KEY8] • 1st row on the cross-point control block (key/AUX bus delegation mode): [KEY1] to [KEY8] buttons • Memory recall section on the Flexi Pad control block (key operation mode): [KEY1] to [KEY8] buttons • Key fader control block: Key delegation buttons Setting the key type You can select the target key to set and set the key type using the key type selection buttons on page 1/3 of the setting buttons. 1 Select a key type using the key type selection buttons. [LUM] button: Luminance key [LIN] button: Linear key [CRK] button: Chroma key [PTN] button: Key wipe pattern key When you press a button, turning it on green, the name and value of the parameter items appear on the display. 2 Set the following parameters. When the [LUM] button or [LIN] button is selected No. Parameter 1 CLIP Adjustment Reference level for key signal generation No. Parameter 2 GAIN 3 DENSITY 4 FILTER Adjustment Key gain Key density Filter (1 to 9) a) a) No filter is applied when set to "1". The larger the value, the stronger the filtering applied. When the [CRK] button is selected No. Parameter 1 CLIP a) 2 GAIN a) 3 HUE a) 4 DENSITY 5 FILTER a) Adjustment Reference level for key signal generation Key gain Key hue Key density Filter (1 to 9) b) a) Displayed only when key active is enabled. b) No filter is applied when set to "1". The larger the value, the stronger the filtering applied. When the [PTN] button is selected No. Parameter 1 SIZE 2 SOFT 3 DENSITY Adjustment Pattern size Softness of the pattern contour Key density To set the wipe pattern for a key wipe pattern key Select a pattern in the Home > M/E-1 > Key1 > Transition > Wipe menu (11101.52) and set modifiers. For details, see "Setting a Wipe Pattern for an Independent Key Transition" (page 158). Note The direction and soft edge cannot be set in a key wipe pattern key. To return the key type parameters to the default values Press and hold the key type selection button (LUM, LIN, CRK, PTN). The key type parameters are returned to the default values. 120