Sony MLS-X1 Users Guide - Page 400
Control Panel Setup, Setting the Control Panel Configuration, Setting the Control Panel
View all Sony MLS-X1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 400 highlights
Control Panel Setup 24 Chapter Setting the Control Panel Configuration Assigning a Switcher Bank/AUX Setting M/E banks and AUX banks (ICP-X7000) You can select control panel rows (up to six) for use as M/E banks and assign switcher banks (M/E-1 to M/E-5, P/P). You can also select control panel rows (up to two) for use as AUX banks and assign AUX (AUX 1 or AUX 2). The bank numbers correspond to the line ID (1 to 14) configured for the control panel banks. Note Only the control panel rows to which an MKS-X7017/ X7018/X7019 cross-point module is connected can be configured. The MKS-X7017/X7018/X7019 functions as a crosspoint control block when the control panel row is configured as an M/E bank or functions as an AUX bus control block when configured as an AUX bank. 1 Open the Home > Setup > Panel > Config > M/E / AUX Assign menu (19104.11). 2 Select the target M/E / AUX bank number to set. 3 Press the [Assign] button and select a switcher bank (M/E-1 to M/E-5, P/P) or AUX (AUX 1, AUX 2) from the pull-down list. To assign no switcher bank or AUX, select [- - -]. Setting M/E banks (ICP-X1000 series) You can select the switcher bank to assign to an M/E bank. The M/E bank number indicates a physical position on the control panel. On a control panel with two M/E bank rows, the rows are numbered 1 and 2 from the back. 1 Open the Home > Setup > Panel > Config > M/E / AUX Assign menu (19104.11). 2 Select the target M/E bank number to set. 3 Press the [Assign] button and select a switcher bank (M/E-1 to M/E-5, P/P) from the pull-down list. To assign no switcher bank, select [- - -]. Setting Switcher Banks in Multi Program 2 Mode In multi program 2 mode, you can set main/sub for each switcher bank assigned to an M/E bank. You can select dedicated main, dedicated sub, or shared main and sub. 1 Open the Home > Setup > Panel > Config > M/E / AUX Assign menu (19104.11). 2 Select the target switcher bank to set. 3 Press the [Main/Sub] button and select main/sub from the pull-down list. Main: Dedicated main Sub: Dedicated sub Main&Sub: Shared main and sub Note When dual M/E is enabled, you can set main and sub to the shifted state and unshifted state of a switcher bank assigned to two M/E banks. The shifted/unshifted settings for dual M/E are cleared. For details about dual M/E, see "Setting Dual M/E" (page 401). 400