Sony MLS-X1 Users Guide - Page 171
Setting the DME wipe pattern position, Position
View all Sony MLS-X1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 171 highlights
Setting the DME wipe pattern position (Position) 1 Open the Home > M/E-1 > Key1 > Transition > DME Wipe menu (11101.53). 2 Set the [Position] button in the [Position] group to the on state and set the following parameters. No. Parameter 1 H 2 V Adjustment Horizontal position • Negative values move left. • Positive values move right. Vertical position • Negative values move down. • Positive values move up. To return the pattern position to the center of the screen Press the [Center] button in the [Position] group. Setting the DME wipe pattern size (Size) 1 Open the Home > M/E-1 > Key1 > Transition > DME Wipe menu (11101.53). 2 Set the [Size] button to the on state and set the following parameter. No. Parameter 1 Size Adjustment Size Setting the DME wipe pattern cropping (Crop) 1 Open the Home > M/E-1 > Key1 > Transition > DME Wipe menu (11101.53). 2 Set the [Crop] button in the [Crop Mode] group to the on state and set the following parameters. No. Parameter 1-1 H 1-2 V 1-3 All 2-1 Top 2-2 Left 2-3 Right 2-4 Bottom Adjustment Simultaneous adjustment of crop of left and right edges Simultaneous adjustment of crop of top and bottom edges Simultaneous adjustment of crop of top, bottom, left, and right edges Crop of top edge Crop of left edge Crop of right edge Crop of bottom edge To crop to 4:3 aspect ratio Press the [4:3 Crop] button in the [Crop Mode] group. To set the movement during transition execution In the [Crop Transition] group, select the crop operation as the transition executes. Cut: The cropping does not change during the transition, and the cropping is removed after the transition has completed. Last 5%: The cropping is maintained for the first 95% of the transition, and is removed during the last 5% of the transition. Linear: The cropping is removed from the start of the transition through the course of the transition. To set the timing of transition completion When the [Last 5%] button in the [Crop Transition] group is selected, you can set the transition completed timing to 70%, 95%, or 100% of the execution time. In the [Release Transition] group, select the timing of transition completion. Last 30%: The transition completes at the 70% point of the transition progress. The transition interval from 70% to 95% becomes a dead band. The cropping is removed during the last 5% of the transition. Last 5%: The transition completes at the 95% point of the transition progress. The cropping is removed during the remaining 5%. Off: The transition completes at the 100% point. During the last 5% of the transition, the transition and cropping removal proceed together. 171