Sony MLS-X1 Users Guide - Page 119
Setting the Key Type Key Control, Block, Setting clean mode, Inverting the key signal
View all Sony MLS-X1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 119 highlights
To set the wipe pattern for a key wipe pattern key Press the [Pattern Select] button and open the Home > M/E-1 > Key1 > Transition > Wipe menu (11101.52). Select a pattern and set modifiers. For details, see "Setting an Independent Key Transition Wipe" (page 158). Note The direction and soft edge cannot be set in a key wipe pattern key. Setting clean mode Note In the following situations, clean mode cannot be enabled. • When the key type is a chroma key or key wipe pattern key • When key invert is enabled • When key position is enabled • When key fill is a color matte • When key edge is an outline • When key edge is normal and soft edge is enabled • When fine key is enabled 1 Open the Home > M/E-1 > Key1 > Type > Type Select menu (11101.11). 2 Enable/disable using the [Clean Mode] button. On: Enable clean mode. Off: Disable clean mode. Inverting the key signal 1 Open the Home > M/E-1 > Key1 > Type > Type Select menu (11101.11). 2 Set key inversion using the [Key Invert] button. On: Invert the key signal. Off: Do not invert the key signal. Setting the key position 1 Open the Home > M/E-1 > Key1 > Type > Type Select menu (11101.11). 2 Set the [Key Position] button to the on state and set the following parameters. No. Parameter 1 H Phase 2 Left 3 Right Adjustment Simultaneous adjustment of position of key left and right edges Position of key left edge Position of key right edge To keep the position of the key signal unchanged, set the [Key Position] button to the off state. Setting the Key Type (Key Control Block) Delegation buttons Adjustment knobs Display Page selection button MORE button Setting buttons AUTO DELEG button To set a key in the key control block, select the target switcher bank and key to operate using the delegation buttons. The key type selection buttons, key fill/key source selection buttons, key modifier setting buttons, and chroma key setting buttons used for operation are assigned to the setting buttons. You can check which functions are configured for the buttons in the setting button display area. Setting buttons for different functions are assigned to three pages (1/3, 2/3, 3/3), where you can switch the page by pressing the page selection button. Setting parameters If a selected function has setup parameters, the name and value of the items appear on the display. The parameter settings are configured using five adjustment knobs (numbered 1 to 5 from the top). If there are six or more parameters, the [MORE] button is lit amber. When the [MORE] button is pressed, turning it on 119