Sony MLS-X1 Users Guide - Page 471
To set standard interface 1 STD 1, To set an interface other than standard interface, STD 1
View all Sony MLS-X1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 471 highlights
The box LAN connectors and configurable LAN types supported by each network interface are shown below. Network I/F STD 1 STD 2 OPT 1 OPT 2 OPT 3 OPT 4 Configurable LAN • Control LAN (Ctrl LAN) • Utility LAN 1 (Util LAN 1) • No setting (Off) • For control LAN redundancy (Ctrl LAN Redundant) • No setting (Off) • Utility LAN 2 (Util LAN 2) • For utility LAN 1 redundancy (Util LAN 1 Redundant) • No setting (Off) • User LAN 1 (User LAN 1) • No setting (Off) • User LAN 2 (User LAN 2) • For user LAN 1 redundancy (User LAN 1 Redundant) • No setting (Off) Connector a) f g p o n m a) Number corresponding to the description of parts on the rear of the box. To set standard interface 1 (STD 1) 1 Open the MLS Manager Home > System > Island > Box Network menu (60211.05). 2 In the [Network I/F] group list, select standard interface 1 network interface of the target box to set. Place a check mark for the target box network interface to set (multiple selection supported). Note Multiple selection is supported only for LANs of the same type (Ctrl LAN). 3 Press the [Edit Network I/F] button. The [Standard Network I/F 1 Settings] window appears. Note The standard interface 1 addresses can only be set manually. 4 Press the [Address] button for [IPv4] and enter an address using the keyboard. Note When multiple network interfaces are selected, consecutively numbered IP addresses are set. 5 Press the [Prefix Length] button for [IPv4] and enter a prefix length in the numeric keypad window. Note When multiple network interfaces are selected, the same prefix length is set for all selected network interfaces. 6 Press [OK]. To set an interface other than standard interface 1 (STD 1) 1 Open the MLS Manager Home > System > Island > Box Network menu (60211.05). 2 In the [Network I/F] group list, select a network interface other than standard interface 1 of the target box to set. Place a check mark for the target box network interface to set (multiple selection supported). Note Multiple selection is supported only for LANs of the same type (such as Util LAN 1 type, User LAN 1 type). 3 Press the [Edit Network I/F] button. A setup window for the selected network interface appears. 4 Press the [LAN] button and select a LAN to set from the pull-down list. The types of LAN which can be set will vary depending on the selected network interface. Note When multiple network interfaces are selected, the [LAN] button is grayed out and cannot be changed. When a LAN for redundancy is selected The same settings as the main LAN are applied. Proceed to step 11. 5 Press the [Mode] button for [IPv4] and select a setup mode from the pull-down list. Off: Do not use IPv4. Manual: Set manually. DHCP: Set automatically using DHCP. When [Off] or [DHCP] is selected, proceed to step 8. 471