Sony MLS-X1 Users Guide - Page 384
Assigning a Cross-Point Assign Table
View all Sony MLS-X1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 384 highlights
On: Set to Hold mode. The shifted state of the crosspoint buttons for all buses is enabled while the [SHIFT ALL] button is pressed. Off: Set to Lock mode. Each time the [SHIFT ALL] button is pressed, the cross-points are switched between the shifted and unshifted states for all buses. Assigning a Cross-Point Assign Table You can select a cross-point assign table to use for each switcher bank or bus. Note In the cross-point control block on the ICP-X7000, you can change the table assignment using the cross-point assign table selection buttons in the cross-point pad. You can also assign a different table to each cross-point button row. 1 Open the Home > Setup > Xpt Assign > Table Assign menu (19102.11). 2 Select the target switcher bank or bus to set. To select and set multiple switcher banks/buses, place a check mark beside the target switcher banks/buses to set. To select and set all switcher banks/buses, place a check mark in the Select All checkbox. 3 Press the [Table Assign] button and select a table (Table1 to Table14) from the pull-down list. Setting the logical V/K pair name table to display on a panel Press the [V/K Pair Panel Display] button and select a logical V/K pair name table to display on a panel from the pull-down list. For details about logical V/K pair name tables, see "Setting a Logical V/K Pair Name Table" (page 381). 384