Sony MLS-X1 Users Guide - Page 481
Configuring Control Panel Bank, Network Settings, To return to the previous setting
View all Sony MLS-X1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 481 highlights
6 Press the [Prefix Length] button and enter a prefix length in the numeric keypad window. Note When multiple LAN ports are selected, the same prefix length is set. 7 Press the [Gateway] button and enter an address using the keyboard. Note When multiple LAN ports are selected, the same gateway is set. 8 Press the [Apply] button. To return to the previous setting Press the [Clear] button, check the message, then press [OK]. 9 Check the message, then press [OK]. To identify the box corresponding to a LAN port Select the target LAN port and press the [Send Beacon] button to cause the front panel LED bars on the box corresponding to the selected LAN port to flash for 5 seconds. Configuring Control Panel Bank Network Settings You can configure the network settings of control panel banks that are not configured in a control panel. For details about configuring the network settings of a control panel not assigned to a switcher in an island, see "Configuring Control Panel Network Settings" (page 467). For details about configuring the network settings of a control panel assigned to a switcher in an island, see "Configuring Control Panel Network Settings" (page 474). 1 Open the MLS Manager Home > System > Off-Island > Panel Network menu (60219.03). 2 Press the [Detect/Refresh] button. Control panel banks that are not configured in a control panel and are on the same network as MLS Manager are detected. Note If no control panel bank connections are detected, the icon is displayed. Press the [Detect/Refresh] button to run control panel bank detection again. 3 Select the target control panel bank to set. Place a check mark for the target control panel bank to set (multiple selection supported). To select and set all control panel banks, place a check mark in the Select All checkbox. 4 Press the [Edit Panel Bank] button. A setup window for the selected control panel bank appears. 5 Press the [Hostname] button and enter a host name (up to 63 characters) using the keyboard. Note Cannot be configured when multiple control panel banks are selected. 6 Press the [Address] button for [IPv4] and enter an address using the keyboard. Note When multiple control panel banks are selected, consecutively numbered IP addresses are set. 7 Press the [Prefix Length] button for [IPv4] and enter a prefix length in the numeric keypad window. Note When multiple control panel banks are selected, the same prefix length is set for all the control panel banks. 8 Press [OK]. 9 Press the [Apply] button. 10Check the message, then press [OK]. To identify a control panel bank Press the [Send Beacon] button to cause the buttons in the selected control panel bank to flash for 5 seconds. 481