Sony MLS-X1 Users Guide - Page 416
Setting the Display/Operation Mode, Setting Levels, Setting Logical V/K Pair Names
View all Sony MLS-X1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 416 highlights
You can also press the [Select Source] button and enter a source number in the numeric keypad window. 5 Press the [Set] button. To inhibit operation of buttons Select the target button and set the [Inhibit] button to the on state. Setting the operation mode of the shift button You can set the operation mode of the [SHIFT] button assigned to the right edge of a cross-point button row (3rd row/4th row) in the AUX bus control block (router operation mode). 1 Open the Home > Setup > Panel > Router > Source Table Assign menu (19104.52). 2 In the [Xpt Shift Mode] group, select an operation mode. Hold: Functions as a shift button, and the shifted state of a cross-point button is enabled while the button is pressed. Lock: Functions as a shift button, and pressing a button toggles between the shifted and unshifted states of the cross-point. Off: Functions as a cross-point button. Setting Levels You can set the enable level for each of the level selection buttons 1 to 4. 1 Open the Home > Setup > Panel > Router > Level Button Assign menu (19104.53). 2 Select the target level selection button (1 to 4) to set. 3 Press the [Edit] button for [Level Assign]. The [Enable Level] window appears. 4 Place a check mark in the levels (1 to 8) to enable. 5 Press [OK]. Setting the Display/ Operation Mode Setting Logical V/K Pair Names/ Source Names and Destination Names You set the logical V/K pair name/source name and destination name to use in the control panel. For details about the logical V/K pair name, see "Setting a Logical V/K Pair Name Table" (page 381). Note The group number of an NS-Bus alias name must be set beforehand. For details, see "Selecting an Alias Name Group" (page 434). 1 Open the Home > Setup > Panel > Custom > Operation Mode menu (19104.61). 2 In the [Source/Dest Name] group, select a name to use in the control panel. Sw'er Local: Use the name set on the switcher. NS-Bus Alias: Use the NS-Bus alias name set in LSM (Live System Manager). 3 In the [Display Name] group, select a name to display in the control panel. Logical V/K Pair Name: Display the logical V/K pair name. Source Name: Display the source name. Note The [Display Name] group is enabled only when [Source/Dest Name] group is set to [Sw'er Local]. 4 In the [Name Display Mode] group, select a display mode. Auto: Display four characters per line, up to four lines. 2 Characters: Display first two characters on one line. 4 Characters: Display first four characters on one line. 416