Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 1006

A route is considered for weighted ECMP calculations only if each path corresponding to that route is configured with a weight. You cannot use the VRF attribute of this command to configure routes in a management VRF. When a specific VRF is deleted, all the configured static routes corresponding to that VRF are automatically removed. Example Related Commands Dell(conf)#ip route 1.1.1.0/24 4.4.4.2 weight 100 Dell(conf)#ip route 1.1.1.0/24 6.6.6.2 weight 200 Dell(conf)#do show running-config | grep route ip route 1.1.1.0/24 4.4.4.2 weight 100 ip route 1.1.1.0/24 6.6.6.2 weight 200 Dell(conf)#ip route vrf test 1.1.1.0/24 4.4.4.2 weight 100 Dell(conf)#ip route vrf test 1.1.1.0/24 6.6.6.2 weight 200 Dell(conf)# Dell(conf)#do show running-config | grep route ip route vrf test 1.1.1.0/24 4.4.4.2 weight 100 ip route vrf test 1.1.1.0/24 6.6.6.2 weight 200 show ip route - views the switch routing table. ip source-route Enable the system to forward IP packets with source route information in the header. C9000 Series Syntax ip source-route To drop packets with source route information, use the no ip route-source command. Defaults Enabled. Command Modes CONFIGURATION Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version 9.9(0.0) 9.2(1.0) 8.3.19.0 8.3.11.1 8.3.7.0 8.1.1.0 7.6.1.0 7.5.1.0 6.1.1.0 Description Introduced on the C9010. Introduced on the Z9500. Introduced on the S4820T. Introduced on the Z9000. Introduced on the S4810. Introduced on the E-Series ExaScale. Introduced on the S-Series. Introduced on the C-Series. Introduced on the E-Series. IPv4 Routing 1006