Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 312

To delete a match, use the no match route-type {local | internal | external [type-1 | type-2] | level-1 | level-2} command. Parameters external [type-1| type-2] internal level-1 level-2 local Enter the keyword external then either type-1 or type-2 to match only on OSPF Type 1 routes or OSPF Type 2 routes. Enter the keyword internal to match only on routes generated within OSPF areas. Enter the keyword level-1 to match IS-IS Level 1 routes. Enter the keyword level-2 to match IS-IS Level 2 routes. Enter the keyword local to match only on routes generated within the switch. Defaults Not configured. Command Modes ROUTE-MAP Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version 9.9(0.0) 9.2(1.0) 8.3.19.0 8.3.11.1 8.3.7.0 8.1.1.0 7.6.1.0 7.5.1.0 6.1.1.0 Description Introduced on the C9010. Introduced on the Z9500. Introduced on the S4820T. Introduced on the Z9000. Introduced on the S4810. Introduced on the E-Series ExaScale. Introduced on the S-Series. Introduced on the C-Series. Introduced on the E-Series. Related Commands match interface - redistributes routes that match the next-hop interface. match ip address - redistributes routes that match an IP address. match ip next-hop - redistributes routes that match the next-hop IP address. match ip route-source - redistributes routes that match routes advertised by other routers. match metric - redistributes routes that match a specific metric. match tag - redistributes routes that match a specific tag. Access Control Lists (ACL) 312