Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 1437

Related Commands Entering port extender configuration mode: DELL(conf)#pe 10 DELL(conf-pe-10)# DELL(conf-pe-10)#stack-unit 0 type c1048P • stack-unit - add or delete a specified port extender stack-unit. • show pe -display the port extender status and details. pe provision Logically provision or add a port extender (PE). C9000 Series Syntax pe provision pe-id To de-provision or delete a port extender, use the no pe provision pe-id command. Parameters pe provision pe-id Enter port-extender configuration mode to logically provision a port extender. Port extender ID range is from 0 to 255 Default None Command Modes CONFIGURATION CONFIGURATION TERMINAL BATCH Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version 9.10(0.0) 9.9(0.0) Description Introduced the Configuration Terminal Batch mode on C9010. Introduced on the C9010. Usage Information Before you provision a port extender, enable the extended bridge feature using the feature extended -bridge command. The pe provision pe-id command logically pre-provisions or adds a port extender (PE) even when the PE is not physically connected to the switch. The port extender ID (pe-id) range is from 0 to 255. After provisioning a PE using the pe provision pe-id , you can provision a stack unit using the stack-unit command. You can provision a port extender connected in a Dual-Homing setup from the Configuration Terminal Batch mode. To de-provision a port extender, use the no pe provision pe-id command. Port Extenders (PE) 1437