Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 1595

router rip To configure and enable RIP, enter ROUTER RIP mode. C9000 Series Syntax router rip To disable RIP, use the no router rip command. Defaults Disabled. Command Modes CONFIGURATION Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version 9.9(0.0) 9.2(1.0) 8.3.19.0 8.3.11.1 8.3.7.0 7.8.1.0 7.6.1.0 6.2.1.1 Description Introduced on the C9010. Introduced on the Z9500. Introduced on the S4820T. Introduced on the Z9000. Introduced on the S4810. Introduced on the S-Series. Introduced on the C-Series. Introduced on the E-Series. Usage Information To enable RIP, assign a network address using the network command. Example Dell(conf)#router rip Dell(conf-router_rip)# Related Commands network - enables RIP. exit - returns to CONFIGURATION mode. show config Display the changes you made to the RIP configuration. The default values are not shown. C9000 Series Syntax show config Routing Information Protocol (RIP) 1595