Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 1475

45 Port Monitoring The port monitoring feature allows you to monitor network traffic by forwarding a copy of each incoming or outgoing packet from one port to another port. Important Points to Remember • Port monitoring is supported on physical ports and logical interfaces, such as port channels and virtual local area networks (VLANs). • The monitoring (destination, "MG") and monitored (source, "MD") ports must be on the same switch. • In general, a monitoring port should have no ip address and no shutdown as the only configuration; Dell Networking OS permits a limited set of commands for monitoring ports; display them using the ? command. A monitoring port also may not be a member of a VLAN. • A total of 4 MG may be configured in a single port-pipe. • MG and MD ports can be reside anywhere across a port-pipe. • The Dell Networking OS supports multiple source ports to be monitored by a single destination port in one monitor session. • One monitor session can have only one MG port. • PE Gigabit Ethernet (peGigE) ports can be added as source ports only. You cannot add cascade ports as destination ports. NOTE: The monitoring port should not be a part of any other configuration. Topics: • description • monitor session • show config • show monitor session • show running-config monitor session • source (port monitoring) description Enter a description of this monitoring session. C9000 Series Syntax description {description} To remove the description, use the no description {description} command. Parameters Defaults description none Enter a description regarding this session (80 characters maximum). Port Monitoring 1475