Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 401

Defaults threshold = 75 Command Modes ROUTER BGP Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version 9.9(0.0) 9.2(1.0) 8.3.19.0 8.3.11.1 8.3.7.0 7.8.1.0 7.7.1.0 Description Introduced on the C9010. Introduced on the Z9500. Introduced on the S4820T. Introduced on the Z9000. Introduced on the S4810. Introduced on the S-Series. Introduced on the C-Series. Usage Information If you configure the neighbor maximum-prefix command and the neighbor receives more prefixes than the neighbor maximum-prefix command configuration allows, the neighbor goes down and the show ip bgp summary command displays (prfxd) in the State/PfxRcd column for that neighbor. The neighbor remains down until you enter the clear ip bgp command for the neighbor or the peer group to which the neighbor belongs or you enter the neighbor shutdown and neighbor no shutdown commands. Related Commands show ip bgp summary - displays the current BGP configuration. neighbor next-hop-self Allows you to configure the router as the next hop for a BGP neighbor. (This command is used for IBGP). C9000 Series Syntax neighbor {ipv6-address | peer-group-name} next-hop-self [all] To return to the default setting, use the no neighbor {ipv6-address | peer-group-name} next-hop-self [all] command. Parameters ipv6-address Enter the IPv6 address in the x:x:x:x::x format. NOTE: The :: notation specifies successive hexadecimal fields of zeros. peer-group-name (OPTIONAL) Enter the name of the peer group. all Specifies that the route reflector is the next hop for both iBGP and eBGP-learned routes. Defaults Disabled. Command Modes ROUTER BGPV6-ADDRESS FAMILY Border Gateway Protocol 401