Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 1414

show ip pim neighbor View PIM neighbors. C9000 Series Syntax Command Modes show ip pim neighbor • EXEC • EXEC Privilege Command History This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version 9.9(0.0) 9.5(0.0) 9.0.2.0 8.3.19.0 8.3.12.0 8.3.11.1 8.1.1.0 7.8.1.0 Description Introduced on the C9010. Introduced on the Z9500. Introduced on the S6000. Introduced on the S4820T. Introduced on the S4810. Introduced on the Z9000. Introduced on the E-Series ExaScale. Introduced on the S-Series. Usage Information The following describes the show ip pim neighbor command shown in the following example. Field Description Neighbor address Displays the IP address of the PIM neighbor. Interface Uptime/expires List the interface type, with either slot/port information or ID (VLAN or Port Channel), on which the PIM neighbor was found. Displays the amount of time the neighbor has been up then the amount of time until the neighbor is removed from the multicast routing table (that is, until the neighbor hold time expires). Ver Displays the PIM version number. • v2 = PIM version 2 DR prio/Mode Displays the Designated Router priority and the mode. • 1 = default Designated Router priority (use the ip pim dr-priority command) • DR = Designated Router • S = Sparse mode PIM-Sparse Mode (PIM-SM) 1414