Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 1495

Version 8.3.7.1 8.2.1.0 Description Introduced on the S4810. Introduced on the C-Series and S-Series. Usage Information Guarantee a minimum bandwidth to different queues globally using the service-class bandwidthpercentage command from CONFIGURATION mode. The command is applied in the same way as the bandwidth-percentage command in an output QoS policy. The bandwidth-percentage command in QOS-POLICY-OUT mode supersedes the service-class bandwidth-percentage command. Use this command in Configuration Terminal Batch mode to specify the minimum bandwidth for queues in a dual-homing setup. service-class dot1p-mapping Configure a service-class criterion based on a dot1p value. C9000 Series Syntax Parameters service-class dot1p-mapping {dot1p0 value | dot1p1 value | dot1p2 value | dot1p3 value | dot1p4 value| dot1p5 value | dot1p6 value | dot1p7 value} dot1p0 value ... dot1p7 value Enter a dot1p list number and value. The list number range is from 0 to 7. The range is from 0 to 7. Defaults For each dot1p Priority, the default CoS queue value is: • Dot1p Priority: 0 1 2 3 4 5 6 7 • Queue: 1 0 2 3 4 5 6 7 Command Modes CONFIGURATION CONFIGURATION TERMINAL BATCH Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version 9.10(0.0) 9.9(0.0) 9.2(1.0) 8.3.19.0 8.3.11.1 8.3.7.0 8.3.16.0 Description Introduced the Configuration Terminal Batch mode on C9010. Introduced on the C9010. Introduced on the Z9500. Introduced on the S4820T. Introduced on the Z9000. Introduced on the S4810. Introduced on the MXL 10/40GbE Switch IO Module. Quality of Service (QoS) 1495