Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 1029

Related Commands R 2.1.3.0/24 via 2.1.4.1, Te 2/43 120/1 C 2.1.4.0/24 Direct, Te 2/43 0/0 3d1h 3d1h ip prefix-list - enters CONFIGURATION-IP PREFIX-LIST mode and configures a prefix list. show ip prefix-list summary - displays a summary of the configured prefix lists. show ip route summary View a table summarizing the IP routes in the switch. C9000 Series Syntax Command Modes show ip route summary • EXEC • EXEC Privilege Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version 9.9(0.0) 9.2(1.0) 8.3.19.0 8.3.11.1 8.3.7.0 8.1.1.0 7.6.1.0 7.5.1.0 6.1.1.0 Description Introduced on the C9010. Introduced on the Z9500. Introduced on the S4820T. Introduced on the Z9000. Introduced on the S4810. Introduced on the E-Series ExaScale. Introduced on the S-Series. Introduced on the C-Series. Introduced on the E-Series. Usage Information The following describes the show ip route summary shown in the following example. Column Heading Description Route Source Identifies how the route is configured in the system. Active Routes Identifies the best route if a route is learned from two protocol sources. Non-active Routes Identifies the back-up routes when a route is learned by two different protocols. If the best route or active route goes down, the non-active route becomes the best route. ospf 100 If routing protocols (OSPF, RIP) are configured and routes are advertised, then information on those routes is displayed. IPv4 Routing 1029