Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 1406

ip pim rp-address Configure a static PIM rendezvous point (RP) address for a group or access-list. C9000 Series Syntax ip pim rp-address address {group-address group-address mask} [override] To remove an RP address, use the no ip pim rp-address address {group-address groupaddress mask} [vrf vrf-name] [override] command. Parameters address group-address group-address mask override Enter the RP address in dotted decimal format (A.B.C.D). Enter the keywords group-address then a group-address mask, in dotted decimal format (/xx), to assign that group address to the RP. Enter the keyword override to override the BSR updates with static RP. The override takes effect immediately during enable/disable. NOTE: This option is applicable to multicast group range. Defaults Not configured. Command Modes CONFIGURATION Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version 9.9(0.0) 9.8(0.0) 9.7(0.0) 9.5(0.0) 9.0.2.0 8.3.19.0 8.3.11.1 8.3.7.0 8.1.1.0 7.8.1.0 pre- 6.1.1.1 Description Introduced on the C9010. Introduced on the S3048-ON and S4048-ON. Added support for VRF. Introduced on the S6000-ON. Introduced on the Z9500. Introduced on the S6000. Introduced on the S4820T. Introduced on the Z9000. Introduced on the S4810. Introduced on the E-Series ExaScale. Introduced on the S-Series. Introduced on the E-Series. Usage Information First-hop routers use this address by to send register packets on behalf of source multicast hosts. The RP addresses are stored in the order in which they are entered. RP addresses learned using BSR take priority over static RP addresses. Without the override option, RPs advertised by the BSR updates take precedence over the statically configured RPs. PIM-Sparse Mode (PIM-SM) 1406