Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 1696

• sflow sample-rate (Interface) • show sflow • show sflow linecard sflow collector Configure a collector device to which sFlow datagrams are forwarded. C9000 Series Syntax sflow collector {ip-address | ipv6-address} agent-addr {ip-address | ipv6address} [number [max-datagram-size number]] | [max-datagram-size number] [vrf management] To delete a configured collector, use the no sflow collector {ip-address | ipv6-address} agent-addr {ipv4-address | ipv6-address} [number [max-datagram-size number]] | [max-datagram-size number] [vrf management] command. Parameters sflow collector ipaddress | ipv6address Enter the IP address of the collector in dotted decimal format for IPv4 or x:x:x:x::x format for IPv6. NOTE: The :: notation specifies successive hexadecimal fields of zeros. agent-addr ipaddress | ipv6address Enter the keyword agent-addr followed by the sFlow agent IP address in dotted decimal format for IPv4 or x:x:x:x::x format for IPv6. NOTE: The :: notation specifies successive hexadecimal fields of zeros. number max-datagramsize number vrf management (OPTIONAL) Enter the user datagram protocol (UDP) port number. The range is from 0 to 65535. The default is 6343. (OPTIONAL) Enter the keyword max-datagram-size then the size number in bytes. The range is from 400 to 1500. The default is 1400. (OPTIONAL) Enter the keyword vrf followed by the keyword management to configure the collector device corresponding to the default VRF and the management VRF respectively. Defaults Not configured. Command Modes CONFIGURATION CONFIGURATION TERMINAL BATCH Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version 9.10(0.0) 9.9(0.0) Description Introduced the Configuration Terminal Batch mode on C9010. Introduced on the C9010. sFlow 1696