Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 1451

Usage Information You can use the write memory local command to write only the local configurations to startup configuration. Debugging Use the commands in this section to debug the port extender hardware. clear hardware system-flow pe Clear the system-flow statistics from the specified port extender hardware component. C9000 Series Syntax Parameters clear hardware system-flow pe pe-id stack-unit unit number port-set port-pipeid counters pe pe-id stack-unit unit number port-set portpipe-id counters Enter the keyword pe and the port extender ID. Range is from 0 to 255. Enter the keyword stack-unit and the stack unit number. Range is from 0 to 7. Enter the keyword port-set and the port pipe number. Port-pipe-id range is from 0 to 48. Enter the keyword counters to reset the system flow entry counter-values. Defaults None Command Modes EXEC Command History This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version 9.9(0.0) Description Introduced on the C9010. Usage Information Use the clear hardware system-flow pe command to clear the system flow statistics on a specified port extender and the stack unit in a PE stack. Use the keywords port-set along with a port-pipe number, then the keyword counters to clear the system-flow counters on the selected port-pipe. The port-pipe value is 0. Example The example below is before and after clearing system-flow counters: Dell#show hardware system-flow pe 255 stack-unit 1 port-set 0 counters EntryId Description #HITS 1024 IPC traffic coming on PE Access Port 0 1023 IPC traffic destined to stack_unit 0 PE CPU 0 1022 IPC traffic destined to stack_unit 1 PE CPU 1011 1021 IPC traffic destined to stack_unit 2 PE CPU 12 1020 IPC traffic destined to stack_unit 3 PE CPU 0 Port Extenders (PE) 1451