Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 1520

Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version 9.10(0.0) 9.9(0.0) 9.2(1.0) 8.3.19.0 8.3.11.1 8.3.7.0 8.2.1.0 7.6.1.0 7.5.1.0 6.1.1.1 Description Introduced the Configuration Terminal Batch mode on C9010. Introduced on the C9010. Introduced on the Z9500. Introduced on the S4820T. Introduced on the Z9000. Introduced on the S4810. Policy name character limit increased from 16 to 32. Introduced on the C-Series and S-Series. Introduced on the C-Series. Introduced on the E-Series. Usage Information To specify the name of the input QoS policy, use this command. After the input policy is specified, ratepolice is defined. This command enables Qos-Policy-Input Configuration mode - (conf-qos-policy-in). When changing a Service-Queue configuration in a QoS policy map, all QoS rules are deleted and readded automatically to ensure that the order of the rules is maintained. As a result, the Matched Packets value shown in the show qos statistics command is reset. If you create create a QoS input policy to be used for CoPP, you must enter the keyword cpu-qos. Use this command in Configuration Terminal Batch mode to create the QoS input policy in a dualhoming setup. Related Commands rate police - incoming traffic policing function. qos-policy-output Create a QoS output policy. C9000 Series Syntax qos-policy-output qos-policy-name To remove an existing output QoS policy, use the no qos-policy-output qos-policy-name command. Parameters Defaults qos-policy-name Enter your output QoS policy name in character format (32 characters maximum). none Quality of Service (QoS) 1520