Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 281

log (OPTIONAL) Enter the keyword log to include ACL messages in the log. threshold-in msgs count (OPTIONAL) Enter the threshold-in-msgs keyword followed by a value to indicate the maximum number of ACL logs that can be generated, exceeding which the generation of ACL logs is terminated with the seq, permit, or deny commands. The threshold range is from 1 to 100. interval minutes (OPTIONAL) Enter the keyword interval followed by the time period in minutes at which ACL logs must be generated. The threshold range is from 1 to 10 minutes. monitor (OPTIONAL) Enter the keyword monitor when the rule is describing the traffic that you want to monitor and the ACL in which you are creating the rule is applied to the monitored interface. For more information, refer to the "Flow-based Monitoring" section in the Port Monitoring chapter of the Dell Networking OS Configuration Guide. Defaults Not enabled. Command Modes CONFIGURATION-MAC ACCESS LIST-STANDARD Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version 9.9(0.0) 9.2(1.0) 8.3.19.0 8.3.11.1 8.3.7.0 8.1.1.0 7.6.1.0 7.5.1.0 7.4.1.0 Description Introduced on the C9010. Introduced on the Z9500. Introduced on the S4820T. Introduced on the Z9000. Introduced on the S4810. Introduced on the E-Series ExaScale. Introduced on the S-Series. Introduced on the C-Series. Added the monitor option. Usage Information When you use the log option, the CP processor logs detail the packets that match. Depending on how many packets match the log entry and at what rate, the CP may become busy as it has to log these packet details. Use the monitor option only when you are using flow-based monitoring. For more information, refer to the Port Monitoring chapter in the C9000 Series Configuration Guide. By default, 10 ACL logs are generated if you do not specify the threshold explicitly. The default frequency at which ACL logs are generated is five minutes. By default, flow-based monitoring is not enabled. NOTE: When ACL logging and byte counters are configured simultaneously, byte counters may display an incorrect value. Configure packet counters with logging instead. Related Commands permit - configures a MAC address filter to pass packets. seq - configures a MAC address filter with a specified sequence number. Access Control Lists (ACL) 281