Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 1581

Parameters weight ip-address mask prefix-name Enter a number from 1 to 255 for the weight (for prioritization). The default is 120. (OPTIONAL) Enter the IP address, in dotted decimal format (A.B.C.D), of the host or network to receive the new distance metric. If you enter an IP address, also enter a mask for that IP address, in either dotted decimal format or /prefix format (/x). (OPTIONAL) Enter a configured prefix list name. Defaults weight = 120 Command Modes ROUTER RIP Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version 9.9(0.0) 9.2(1.0) 8.3.19.0 8.3.11.1 8.3.7.0 7.8.1.0 7.6.1.0 6.2.1.1 Description Introduced on the C9010. Introduced on the Z9500. Introduced on the S4820T Introduced on the Z9000. Introduced on the S4810. Introduced on the S-Series. Introduced on the C-Series. Introduced on the E-Series. Related Commands default-metric - assigns one distance metric to all routes learned using the redistribute command. distribute-list in Configure a filter for incoming routing updates. C9000 Series Syntax distribute-list prefix-list-name in [interface] To delete the filter, use the no distribute-list prefix-list-name in command. Parameters prefix-list-name interface Enter the name of a configured prefix list. (OPTIONAL) Identifies the interface type slot/port as one of the following: • For a Port Channel interface, enter the keywords port-channel then a number. The range is from 1 to 4096. • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port information. Routing Information Protocol (RIP) 1581