Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 957

clear ip igmp snooping groups Clear snooping entries from the group cache table. C9000 Series Syntax Parameters clear ip igmp snooping groups [group-address interface | interface] group-address (OPTIONAL) Enter the IP multicast group address in dotted decimal format. interface interface Enter the following keywords and slot/port or number information: • For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet then the slot/port information. • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port information. • For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/port information. • For a port channel interface, enter the keywords port-channel then a number. Command Modes EXEC Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version 9.9(0.0) 9.7(0.1) 9.7(0.0) Description Introduced on the C9010. Introduced on the S3048-ON and S4048-ON. Introduced on S-Series and Z-Series. Usage Information IGMP commands accept only non-VLAN interfaces - specifying VLAN does not yield results. debug ip igmp snooping Enable debugging of IGMP snooping packets on interfaces and groups. C9000 Series Syntax Parameters debug ip igmp snooping [group address | interface] • To disable debugging of IGMP snooping, use the no debug ip igmp snooping [group address | interface] command. • To disable all debugging, use the undebug all command. snooping Enter the keyword snooping to enable debugging of IGMP snooping. Internet Group Management Protocol (IGMP) 957