Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 264

Example Related Commands Total Ports: 4001 An ACL rule with a TCP port lt 1023 uses only one entry in the CAM. Rule# Data Mask From To #Covered 1 0000000000000000 1111110000000000 0 1023 1024 Total Ports: 1024 ip access-list extended - creates an extended ACL. permit - assigns a permit filter for IP packets. permit tcp - assigns a permit filter for TCP packets. resequence prefix-list ipv4 Re-assign sequence numbers to entries of an existing prefix list. C9000 Series Syntax Parameters resequence prefix-list ipv4 {prefix-list-name StartingSeqNum Step-to-increment} prefix-list-name StartingSeqNum Step-toIncrement Enter the name of the configured prefix list, up to 140 characters long. Enter the starting sequence number to resequence. The range is from 0 to 65535. Enter the step to increment the sequence number. The range is from 1 to 65535. Defaults Command Modes none • EXEC • EXEC Privilege Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version 9.9(0.0) 9.2(1.0) 8.3.11.1 8.1.1.0 7.8.1.0 7.6.1.0 Description Introduced on the C9010. Introduced on the Z9500. Introduced on the Z9000. Introduced on the E-Series ExaScale Increased the name string to accept up to 140 characters. Prior to 7.8.1.0, names were up to 16 characters long. Introduced on the S-Series. Access Control Lists (ACL) 264