Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 298

seq To a deny or permit filter in a prefix list while configuring the filter, assign a sequence number. C9000 Series Syntax seq sequence-number {deny | permit} {any} | [ip-prefix /nn {ge min-prefixlength} {le max-prefix-length}] | [bitmask number] To delete a specific filter, use the no seq sequence-number {deny | permit} {any} | [ipprefix {ge min-prefix-length} {le max-prefix-length}] | [bitmask number]. Parameters sequencenumber deny permit any ip-prefix /nn ge min-prefixlength le max-prefixlength bitmask number Enter a number. The range is from 1 to 65534. Enter the keyword deny to configure a filter to drop packets meeting this condition.. Enter the keyword permit to configure a filter to forward packets meeting this condition. (OPTIONAL) Enter the keyword any to match any packets. (OPTIONAL) Specify an IP prefix in the network/length format. For example, 35.0.0.0/8 means match the first 8 bits of address 35.0.0.0. (OPTIONAL) Enter the keyword ge and then enter the minimum prefix length, which is a number from zero (0) to 32. (OPTIONAL) Enter the keyword le and then enter the maximum prefix length, which is a number from zero (0) to 32. Enter the keyword bitmask then enter a bit mask number in dotted decimal format. Defaults Not configured. Command Modes PREFIX-LIST Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version 9.9(0.0) 9.2(1.0) 8.3.19.0 8.3.11.1 8.3.7.0 8.1.1.0 7.6.1.0 Description Introduced on the C9010. Introduced on the Z9500. Introduced on the S4820T. Introduced on the Z9000. Introduced on the S4810. Introduced on the E-Series ExaScale. Introduced on the S-Series. Access Control Lists (ACL) 298