Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 1435

Usage Information This command enables support for the 802.1 bridge PE (BR) on the switch. Enabling the PE feature allows you to provision the PE. The no feature extended-bridge command disables bridge PE support and deprovisions a PE. When you use this command in the Configuration Terminal Batch mode, you can enable the support for the bridge PE connected in a Dual-Homing setup. You can use the show feature command to check whether the extended-bridge feature has been enabled as shown in the following example. Example Related Commands Dell>show feature Feature ------VRF Extended-Bridge State ----disabled enabled pe provision - Logically provision or add a PE. location-led Toggle the location LED of a specified interface, linecard or port extender (PE) on or off. C9000 Series Syntax Parameters Default location-led {interface interface | linecard slot-id | pe pe-id stack-unit unit-number | rpm slot-id }{off|on} interface interface Enter the following keywords and slot/port or number information: • For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/port information. • For a Gigabit Ethernet interface, enter the keyword gigabitethernet then the slot/port information. • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port information. linecard slot-id pe pe-id stack-unit unit number rpm slot-id on |off Enter the keyword linecard and the slot ID. The linecard slot-id range is from 0 to 9. Enter the keyword pe and the PE ID. The range is from 0 to 255. Enter the keyword stack-unit and the stack unit number. The range is from 0 to 7. Enter the keyword rpm and specify the route processor slot ID. RPM slot-id values are rpm0 and rpm1 . Turn the location LED(s) of the specified interfaces, linecard, port extenders (PE), ports and RPMs on or off. None Command Modes EXEC Privilege Port Extenders (PE) 1435