Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 1466

NOTE: The max_milliwatt configuration is effective only in Static mode. priority critical high low Enter the keyword priority to specify the PoE priority for the powered device connected to the interface. Default priority value is low. Enter the keyword critical to set the PoE priority level as critical. Enter the keyword high to set the PoE priority level as high. Enter the keywordlow to set the PoE priority as low. Defaults Default priority is low. Command Modes INTERFACE CONFIGURATION Command History This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version 9.9(0.0) Description Introduced on the C9010. Usage information The power inline [max_milliwatts} command enables inline power supply to an interface. You can specify the maximum amount of power allocation to a device in max-milliwatts, within a range of 440-30000 mW. If a specific power supply value is not configured, the default value of 30,000 mW is configured as the maximum power for allocation to powered devices. You can disable the inline power supply to a port using the no power inline command. The power inline priority command allows you to specify the power inline priority for an interface when a power shortage occurs. PoE is removed from ports configured with low priority first, then ports configured with high priority are disabled. The ports configured with critical priority are the last ports disabled during a power shortage. When two or more ports are configured with same priority level, the ports with higher interface numbers are disabled first. For example, if ports 1, 2, 47, and 48 are all configured with a low priority and there is a shortage of inline power supply, PoE is first disabled on port 48, followed by port 47 and, then port 2. Port 1 (with the lowest interface number) takes precedence over all other ports and is disabled after all other ports are disabled. Example Dell(conf)#int peGigE 0/0/0 Dell(conf-if-pegi-0/0/0)#power inline 30000 Dell(conf-if-pegi-0/0/0)#power inline priority critical Dell(conf-if-pegi-0/0/0)# Dell#show power inline pe 0 stack-unit 0 Global inline power Threshold : 99 Power Reserved for inline Power : 841W Total Inline Power Consumed : 0W Remaining inline power Available : 841W Power Management Mode : Static Interface LLDP Support PeGi 0/0/0 0 Inline Power Max / Alloc (Watts 30.00/0.00 Inline Power Consumed (Watts 0.00 Class Device Type NO_PD - PoE Port Priority -------critical Port Extenders (PE) 1466