Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 283

Example Use this command in Configuration Terminal Batch mode to configure a standard MAC ACL, name in a dual-homing setup. Dell(conf)#mac-access-list access-list standard TestMAC Dell(config-std-macl)#? deny Specify packets to reject description List description exit Exit from access-list configuration mode no Negate a command or set its defaults permit Specify packets to forward remark Specify access-list entry remark seq Sequence numbers show Show Standard ACL configuration permit To forward packets from a specific source MAC address, configure a filter. C9000 Series Syntax Parameters permit {any | mac-source-address [mac-source-address-mask]} [count [byte]] | [log [interval minutes] [threshold-in-msgs [count]] [monitor] To remove this filter, you have two choices: • Use the no seq sequence-number command if you know the filter's sequence number. • Use the no permit {any | mac-source-address mac-source-address-mask} command. any Enter the keyword any to forward all packets received with a MAC address. mac-sourceaddress Enter a MAC address in nn:nn:nn:nn:nn:nn format. mac-sourceaddress-mask (OPTIONAL) Specify which bits in the MAC address must match. If no mask is specified, a mask of 00:00:00:00:00:00 is applied (in other words, the filter allows only MAC addresses that match). count (OPTIONAL) Enter the keyword count to count packets processed by the filter. byte (OPTIONAL) Enter the keyword byte to count bytes processed by the filter. log (OPTIONAL) Enter the keyword log to include ACL messages in the log. threshold-in msgs count (OPTIONAL) Enter the threshold-in-msgs keyword followed by a value to indicate the maximum number of ACL logs that can be generated, exceeding which the generation of ACL logs is terminated with the seq, permit, or deny commands. The threshold range is from 1 to 100. interval minutes (OPTIONAL) Enter the keyword interval followed by the time period in minutes at which ACL logs must be generated. The threshold range is from 1 to 10 minutes. monitor (OPTIONAL) Enter the keyword monitor when the rule is describing the traffic that you want to monitor and the ACL in which you are creating the rule is applied to the monitored interface. For more information, refer to the "Flow-based Monitoring" section in the Port Monitoring chapter of the Dell Networking OS Configuration Guide. Access Control Lists (ACL) 283