Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 767

Command History This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version 9.9(0.0) 8.3.19.0 8.3.11.1 8.3.7.0 8.1.1.0 7.5.1.0 7.6.1.0 Description Introduced on the C9010. Introduced on the S4820T. Introduced on the Z9000. Introduced on the S4810. Introduced on the E-Series ExaScale. Introduced on the C-Series. Introduced on the E-Series. Data between the two RPMs or PEs is synchronized immediately after bootup. Once the two RPMs or PEs complete an initial full synchronization (block sync), the Dell Networking OS updates changed data (incremental sync).The data that is synchronized consists of configuration data, operational data, state and status, and statistics depending on the Dell Networking OS version. show redundancy Display the current redundancy configuration. C9000 Series Syntax show redundancy pe pe-id From a PE console, use show redundancy to view the current high availability (HA) status for a specified port extender unit. Parameters pe pe-id Enter the keyword pe and the port extender ID to display the current redundancy configuration of the specified port extender unit. Range is from 0 to 255 Command Modes • EXEC • EXEC Privilege Command History This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version 9.9(0.0) 9.2(0.0) Description Introduced on the C9010 and C1048P. Introduced on the M I/O Aggregator. This command is supported in Programmable-Mux (PMUX) mode only. High Availability (HA) 767