Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 555

Example Term Linecard Portpipe CAM Partition Available CAM Estimated CAM per Port Status Explanation Lists the line cards that are checked. Entering all displays the status for line cards in the chassis. Lists the port pipes (port sets) that are checked. Entering all displays the status for all line cards and port pipes in the chassis. Shows the CAM profile of the CAM. Identifies the amount of CAM space remaining for that profile. Estimates the amount of CAM space the listed policy will require. Indicates whether or not the policy will be allowed in the CAM. Dell# test cam-usage service-policy input pcam linecard all linecard |Portpipe|CAM Partition|Available CAM |Estimated CAM per Port|Status 0 | 0 | IPv4Flow | 408 | 1 | Allowed (408) 0 | 1 | IPv4Flow | 408 | 1 | Allowed (408) 0 | 2 | IPv4Flow | 408 | 1 | Allowed (408) 1 | 0 | IPv4Flow | 408 | 1 | Allowed (408) 1 | 1 | IPv4Flow | 408 | 1 | Allowed (408) 1 | 2 | IPv4Flow | 408 | 1 | Allowed (408) 1 | 3 | IPv4Flow | 408 | 1 | Allowed (408) 2 | 0 | IPv4Flow | 408 | 1 | Allowed (408) 2 | 1 | IPv4Flow | 408 | 1 | Allowed (408) 2 | 2 | IPv4Flow | 408 | 1 | Allowed (408) 2 | 3 | IPv4Flow | 408 | 1 | Allowed (408) Unified Forwarding Table Modes Unified Forwarding Table (UFT) consolidates the resources of several search tables (Layer 2, Layer 3 Hosts, and Layer 3 Route [Longest Prefix Match - LPM]) into a single flexible resource. Trident 2 supports several UFT modes to extract the forwarding tables, as required. By default, Dell Networking OS initializes the table sizes to UFT mode 2 profile, since it provides a reasonable shared memory for all the tables. The other supported UFT modes are scaled-l3-hosts (UFT mode 3) and scaledl3-routes (UFT mode 4). Important Points to Remember • All line cards/Stack Members within a single system must have the same UFT mode profiles. this profile must match the system UFT mode profile (the profile on the primary route processor module [RPM]/ Master Unit of the Stack). • The UFT mode configuration is applied to the entire system when you use the CONFIGURATION mode commands. Save the running-configuration to affect the change. • You MUST save your changes and reboot the system for UFT mode profiling to take effect. show hardware forwarding-table mode Display the hardware forwarding table mode in the current boot and in the next boot. Syntax Defaults show hardware forwarding-table mode none Command Modes EXEC Privilege Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. Content Addressable Memory (CAM) 555