Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 227

remark Enter a description for an ACL entry. C9000 Series Syntax Parameters remark [remark-number] [description] remark-number Enter the remark number. The range is from 0 to 65535. NOTE: You can use the same sequence number for the remark and an ACL rule. description Enter a description of up to 80 characters. Defaults Command Modes Not configured. • CONFIGURATION-IP ACCESS LIST-STANDARD • CONFIGURATION-IP ACCESS LIST-EXTENDED • CONFIGURATION-MAC ACCESS LIST-STANDARD • CONFIGURATION-MAC ACCESS LIST-EXTENDED Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version 9.9(0.0) 9.2(1.0) 8.3.19.0 8.3.11.1 8.3.7.0 8.1.1.0 7.6.1.0 7.5.1.0 6.4.1.0 Description Introduced on the C9010. Introduced on the Z9500. Introduced on the S4820T. Introduced on the Z9000. Introduced on the S4810. Introduced on the E-Series ExaScale. Introduced on the S-Series. Introduced on the C-Series. Introduced on the E-Series. Usage Information The remark command is available in each ACL mode. You can configure up to 4294967290 remarks in a given ACL. The following example shows the use of the remark command twice within CONFIGURATIONSTANDARD-ACCESS-LIST mode. The same sequence number was used for the remark and for an associated ACL rule. The remark precedes the rule in the running-config because it is assumed that the remark is for the rule with the same sequence number, or the group of rules that follow the remark. Example Dell(config-std-nacl)#remark 10 Deny rest of the traffic Dell(config-std-nacl)#remark 5 Permit traffic from XYZ Inc. Access Control Lists (ACL) 227